I was running a model where water level in the reservoir is one of the output. After running the model, the water level results are always presented as whole number. For example if the water level in one time step is 100m, it will maintain the same 100 m value for a series of time steps and suddenly change to another whole number such as 101m or 99 m. I wonder why the GOLDSIM is not providing a detailed result that show the exact water level such as 100.3m, 100.5m, 99.7m etc. instead of switching only between whole numbers?
Is there anyway that I can change to get the water level results not necessarily as whole number only but as rational number too. See the screenshot below that shows the water level.